At this time we have only two 110 housings remaining in inventory.
The Brinno ATH 110 weather resistant housing protects your Brinno TLC 200 f/1.2 camera from rain, splashing and dust. The design allows for easy removal of the camera without adjusting the camera position. This feature is great for indoor use, as the camera can be attended without changing the shooting angle. The 1/4"X20 screw mount in the base will allow the housing to be threaded onto a standard camera tripod or clamp.
- Water-Resistant: IPX4
- Clear Polycarbonate Construction
- Rubber Control Buttons
- Accommodates TLC200 f/1.2 Camera
- 1/4" X 20 Screw Mount Base
Special Notes: For outdoor use, we recommend wrapping the seal area with tape to prevent driving rain from penetrating the seal. This is just an added precautionary measure, chances are your housing will be fine without tape. However, we have seen a few instances of moisture getting through after a bad storm. Tape is cheap insurance for your time lapse project's success. The 2" wide gaffer tape we offer is perfect but any weather proof tape, including duct tape, will work.
This housing comes with a clear protective plastic film over the lens port. The plastic is very hard to see but must be peeled off to prevent blurry videos. See photo above.